IIT JEE/IIT JEE Atoms Molecules And Chemical Arithmetic Sample Test,Sample questions

Question:
0.6 mol of barium chloride in solution is mixed with 0.2 mol of sodium phosphate the amount of barium phosphate produced is

1.0.1 mol

2.0.3 mol

3.0.4 mol

4.0.5 mol.


Question:
12 g of Mg (at. Mass 24) react with dilute mineral acid to produce maximum hydrogen equal to

1.0.5 mol

2.1.5 mol

3.1.5 g

4.1 g-atom.


Question:
142 g of chlorine represents

1.Two g-molecules of chlorine

2.4 moles of chlorine atoms

3.Two moles of Cl atoms

4.Both a b.


Question:
27 g of Al will completely react with.

1.3 mol of oxygen

2.3 g-atoms of oxygen

3.3 g-equivalents of oxygen

4.3 atoms of oxygen


Question:
27 g of aluminium will react completely with

1.8 g of oxygen

2.24 g of oxygen

3.16 g of oxygen

4.48 g of oxygen.


Question:
276 g of silver carbonate on being strongly heated yields a residue weighing.

1.2.16 g

2.3.0 g

3.6.2 g

4.2.48 g


Question:
30 mL of an acid is neutralized by 15 mL of 0.2 N alkali. The strength of the acid is

1.0.1 N

2.0.2 N

3.0.3 N

4.0.4.


Question:
33.6 L of water vapour at S.T.P. are condensed to liquid state. The volume occupied by it is approximately.

1.1 L

2.18 ml

3.27 L

4.127 ml


Question:
4 g of hydrogen is ignited with 4 g of oxygen the amount of water Formed is

1.2.5 g

2.0.5 g

3.4.5 g

4.8 g.


Question:
50 ml of samples of distilled water ordinary tap water and boiled tap water requires 2 ml 26 and 10 of soap solution respectively to form permanent lather. The ratio of permanent hardness to temporary hardness in tap water is

1.1:02

2.3:02

3.2:00

4.2:01


Question:
A certain gaseous mixture contains methane and sulphur dioxide in ratio of 1: 8 by mass. The ration of the number of molecules is

1.1:08

2.1:02

3.1:01

4.2:01


Question:
A mixture of sand and naphthalene can be separted by.

1.Fractional crystallisation

2.Chromatography

3.Gravity separation

4.Sublimation


Question:
Among the pairs of compounds given below which pair contains compounds with different percentage of carbon?.

1.propene and propane

2.butane and isobutene

3.acetylene and benzene

4.propene cyclopropane


Question:
During synthesis of ammonia from its constituent elements the volume of the product relative to the total volume of thereacting species is.

1.one-fourth

2.three-fourth

3.one-half

4.one-eighth


Question:
If atomic mass of oxygen were taken as 100 the molecular mass of water would be Approximately

1.6.25

2.112.5

3.102

4.106.25.


Question:
If given sample of potassium chlorate is 80% pure then 48 g of oxygen would be produced from

1.98.0 g of the sample

2.153.12 g of sample

3.245 g of sample

4.122.5 g of sample.


Question:
If specific heat of certain element is 0.064. Its approximate atomic mass is200

1.100

2.10

3.20

4.200


Question:
On dividing 0.86 by 16.564 the actual answer is 0.0519198. The correctly reported answer will be

1.0.05

2.0.051

3.0.0519

4.0.05191.


Question:
On rendering anhydrous the sample of hexahydrate calcium (II) chloride loses

1.39.4% of its mass

2.49.3% of its mass

3.46.5% of its mass

4.43.9% of its mass.


Question:
Sodium carbonate crystals lose water molecules on exposure to atmosphere. The related property is called.

1.Deliquescence

2.Fluorescence

3.Efflorescence

4.Luminescence


Question:
The balancing of chemical equation is based upon.

1.Law of combining volumes

2.Law of multiple proportions

3.Law of conservation of mass

4.Law of definite proportion


Question:
The compound AB contains elements A and B in the ratio of 1:35.5 by mass. The mass of B that will be required to react with 2 g of A is

1.7.1 g

2.3.55 g

3.71 g

4.35.5 g.


Question:
The compounds with identical crystal structures and analogouschemical formulae are calledallotropes.

1.allotropes

2.isotones

3.isotones

4.isomorphs


Question:
The conversion of oxygen to ozone occurs to the extent of 15% only. The mass of ozone that can be prepared from 67.2 L of oxygen at N.T.P. will be

1.14.4 g

2.96 g

3.640 g

4.64 g.


Question:
The correctly reported difference of 18.3426 and 8.06 willhave significant figures equal to

1.three

2.four

3.five

4.six.


Question:
The density of chlorine relative to air is.

1.3

2.2.46

3.4


Question:
The mass of 60% HCl required for the neutralization of 10 L of 0.1 M KOH is

1.60.8 g

2.21.9 g

3.100 g

4.219 g.


Question:
The mass of 60% HCl required for the neutralization of 10 L of 0.1 M KOH is

1.60.8 g

2.21.9 g

3.100 g

4.219 g.


Question:
The molality of a solution containing 5 g of sodium hydroxide in 250 g of solution

1.0.5 m

2.1.0 m

3.2.0 m

4.0.1 m.


Question:
The molarity of the solution containing 2.8% mass-volume solution of KOH is

1.M/10

2.M/2

3.M/5

4.1 M.


Question:
The mole fraction of solute in 1 molal aqueous solution is

1.0.0176

2.1.8

3.0.05

4.0.98.


Question:
The mole fraction of solute in 1 molal aqueous solution is

1.0.0177

2.1.8

3.0.05

4.0.98


Question:
The mole fraction of water in a solution containing 117 g sodium chloride and 900 g of water is

1.0.0632

2.0.038

3.0.9615

4.1.000.


Question:
The number of atoms is largest in

1.71 g of chlorine

2.48 g of magnesium

3.127 g of iodine

4.4 g of hydrogen.


Question:
The number of moles of lead nitrate which are required to be decomposed to produce 48 of Oxygen

1.3 mol

2.1.5 mol

3.0.15 mol

4.0.3 mol.


Question:
The number of moles of NaCl in 3 L of 3 M NaCl solution is

1.1

2.3

3.9

4.6


Question:
The number of moles of oxygen in one litre of air (21% oxygen by volume) at S.T.P. would be

1.0.186 mol

2.0.21 mol

3.2.10 mol

4.0.0093 mol.


Question:
The number of moles of sodium oxide present in 620 g of it are

1.1 mol

2.10 mol

3.18 mol

4.100 mol.


Question:
The percentage of hydrogen in water and hydrogen peroxide is11.1 and 5.9% respectively. These figures illustrate

1.Law of multiple proportions

2.Law of conservation of mass

3.Law of reciprocal proportions

4.Law of combining volumes.


Question:
The volume of oxygen required for complete combustion of 20 ml of ethane is

1.30 ml

2.60 ml

3.40 ml

4.50 ml.


Question:
Vapour density of a metal chloride is 77. The equivalent mass is 3. Its atomic mass would be

1.3

2.6

3.9

4.12


Question:
When 4.0 g of iron is burnt at high temperature to ferric oxide at constant pressure 29.28 kJ Of heat is evolved. The amount of heat evolved for producing one mole of ferric oxide is

1.819.84 kJ

2.40.99 kJ

3.81.98 kJ

4.409.9 kJ.


Question:
Which of following acid can show optical isomerism?

1.2 2-Dimathylpropanoic acid

2.2-Methylpropanoic acid

3.2-Methylbutanoic acid

4.Ethanoic acid.


Question:
Which of the following best explains the law of conservation of mass?

1.No change in mass is observed when 2.0 g of Mg is heated in vacuum

2.1.2 g of carbon when burnt in excess if oxygen consumes only 3.2 g of it to form 4.4 g of carbon dioxide

3.12 g of carbon when heated in limited supply of air produces only 20 g of carbon monoxide

4.A sample of air in heating does not show any change in mass but volume increases.


Question:
Which of the following does not have same number of atoms?

1.1 g of oxygen and 1 gm-atom of hydrogen

2.1 g of oxygen and 1 gm of ozone

3.1 g of hydrogen and 1 gm-atom of hydrogen

4.4 g of calcium and 0.1 gm-atom of calcium.


Question:
Which of the following does not have same percentage ofcarbon as in ethane?

1.2-Butene

2.Cyclohexane

3.Cylohexne

4.2-Methyl but-2ene.


Question:
Which of the following illustrates the law of conservation of mass?

1.Mixing of 10 g of sulphur and 2 g of sand does not show a change in mass

2.The mass of platinum wire before and after heating remains constant

3.2.2 g of propane and 8 g of oxygen produces 10.2 g of gaseous mixture

4.2.8 g of CO and 1.6 g of oxygen gave only 2.24 L of CO2 at S.T.P.


Question:
Which one of the following solution of sulphuric acid will exactly neutralize 25 ml of 0.2 M NaOH solution?

1.12.5 ml of 0.1 M solution

2.25 ml of 0.2 M solution

3.25 ml of 0.1 M solution

4.50 ml of 0.2 M solution.


More MCQS

  1. IIT JEE Heat And Thermodynamics
  2. IIT JEE PHYSICS Current Electricity
  3. IIT JEE Fluids At Rest
  4. IIT JEE Description Of Motion In One Dimension part1
  5. IIT JEE Magnetic Effect Of Current And Magnetism
  6. IIT JEE Principles Of Communication set-1
  7. IIT JEE Principles Of Communication set-2
  8. IIT JEE Description Of Motion In One Dimension part2
  9. IIT JEE Electromagnetic Induction Electromagnetic Waves Part-1
  10. IIT JEE Circular Motion Centre Of Mass
  11. IIT JEE Elasticity
  12. IIT JEE Motion In Two And Three Dimensions part1
  13. IIT JEE Electromagnetic Induction Electromagnetic Waves Part 2
  14. Electrons And Dual Nature Of Matter And Radiations
  15. IIT Chemistry Of Lighter Metals
  16. IIT JEE Gravitation part1
  17. IIT JEE Gravitation part 2
  18. IIT JEE Laws Of Motion
  19. IIT JEE Alcohols And Phenols
  20. IIT JEE CHEMISTRY Biomolecules And Biological Processes
  21. IIT JEE CHEMISTRY Chemical Bonding And Molecular Structure Part-1
  22. IIT JEE Gaseous State
  23. IIT JEE Organic Compounds Containing Halogens
  24. IIT JEE Qualitative Inorganic Analysis
  25. IIT JEE Solid State
  26. IIT JEE Atoms Molecules And Chemical Arithmetic
  27. IIT JEE Aldehydes And Ketones
  28. IIT JEE Chemistry Of Non Metals
  29. IIT JEE Chemistry Of Heavier Metals
  30. IIT JEE Isomerism And Stereochemistry
  31. IIT JEE Organic Compounds Containing Nitrogen
  32. IIT JEE Environmental Chemistry set 1
  33. IIT JEE Chemical Energetics And Thermodynamics
  34. IIT JEE CHEMISTRY Chemical Bonding And Molecular Structure Part-2
  35. IIT JEE Environmental Chemistry set 2
  36. IIT JEE Solutions Mcq Questions Part-1
  37. IIT JEE Synthetic And Natural Polymers Part 1
  38. IIT JEE Synthetic And Natural Polymers Part 2
  39. IIT JEE Transition Metals Including Lanthanides
  40. IIT JEE Atomic Structure
  41. IIT JEE Solutions Mcq Questions part 2
  42. IIT JEE Carboxylic Acids And Their Derivatives
  43. IIT JEE Chemical Equilibrium
  44. IIT JEE Chemistry Of Hydrocarbons Part 1
  45. IIT JEE Chemistry Of Hydrocarbons Part 2
  46. IIT JEE Chemistry Of Representative Elements
  47. IIT JEE Fundamental Concepts Of Organic Chemistry
  48. IIT JEE Surfaces And Catalysis
  49. IIT JEE Redox Reactions And Electrochemistry
  50. Mechanical Engineering Engineering Mechanics Part 1
  51. Mechanical Engineering Engineering Mechanics Part-2
  52. Programming Computer Architecture
  53. IIT JEE Purification Of Organic Compounds .
  54. IIT JEE Nuclear Chemistry
  55. Basic Civil Engineering Questions and Answers
Search
R4R Team
R4Rin Top Tutorials are Core Java,Hibernate ,Spring,Sturts.The content on R4R.in website is done by expert team not only with the help of books but along with the strong professional knowledge in all context like coding,designing, marketing,etc!